shell> ./configure --prefix=/usr/local/php --with-apxs2=/usr/local/apache2/bin/apxs --with-gd=/usr/local/gd2 --with-jpeg-dir=/usr/local/jpeg-6b --with-zlib-dir=/usr/local/zlib --with-png-dir=/usr/local/libpng --with-freetype-dir=/usr/local/freetype --enable-trace-vars -with-mysql=/usr/local/mysql -with-iconv=/usr/local/iconv --enable-mbstring=all --with-curl --enable-track-vars --with-DBA --enable-mbstr-enc-trans --enable-mbregex --with-config-file-path=/usr/local/php --with-xml --with-gettext
shell> make
shell> make install
shell> cp php.ini-dist /usr/local/php/php.ini

編輯apache配置檔
shell> cd /usr/local/apache2/conf
shell> vi httpd.conf
在LoadModule php4_module modules/libphp4.so
添加AddType application/x-httpd-php .php

OK,基礎的安裝已經完成,如果重新起動APACHE出現:/usr/local/apache2/bin/apachectl start Syntax error on line 232 of /usr/local/apache2/conf/httpd.conf: Cannot load /usr/local/apache2/modules/libphp4.so into server: /usr/local/apache2/modules/libphp4.so: cannot restore segment prot after reloc: Permission denied
那就要按照下面的方法解決:

編輯/etc/selinux/config，找到這段：
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
SELINUX=enforcing

把 SELINUX=enforcing 注釋掉：#SELINUX=enforcing ，然后新加一行為：
SELINUX=disabled
保存，關閉。

編輯/etc/sysconfig/selinux，找到:
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
SELINUX=enforcing

如果SELINUX已經是 SELINUX=disabled，那么就不用改了，否則就把SELINUX=enforcing 注釋掉，新加一行：
SELINUX=disabled
保存，退出。

如果你碰到其他類似提示：
cannot restore segment prot after reloc: Permission denied
哪應該是SELinux的問題，可以考慮把它關閉。

關鍵字：php5 install

【 頂部 】 【 關閉 】